Wattive TM12 Countdown Timer Socket User Manual

Wattive TM12 Countdown Timer Socket

Tuotteen tekniset tiedot

• Working voltage: 230V
• Toimintataajuus: 50 Hz
• Max. Nykyinen: 16A
• Max. Latausteho: 3680W
• Tarkkuus: +/- 1 %

Tuotteen käyttöohjeet

1. Setting the Countdown Time:
   • Paina lyhyesti SARJA key to cycle through the available countdown times.
   • The available countdown times are: 10m, 20m, 30m, 40m, 50m, 1h, 2h, 4h, 6h, 8h, 10h, 12h.
2. Lähtölaskenta:
   • Kun haluttu lähtölaskenta-aika on asetettu, paina ON/OFF key to start the countdown.
   • The timer will count down from 0 until the set time is reached, then it will automatically stop.
3. Stopping the Countdown Manually:
   To stop the countdown before it completes, press the ON/OFF avain uudelleen.

Tuotteen vianmääritys

• Ajastin ei käynnisty: Ensure that a countdown time has been set using the SARJA avain. The ON/OFF key is invalid if no countdown time is set.
• Unable to change countdown time during operation: The SARJA key is invalid while the countdown is running. Stop the countdown first by pressing ON/OFF, then set a new time.

KÄYTTÖ

• Short-press the “SET” key to set the countdown time.
• Set the countdown time by following: 10m-20m-30m-40m-50m-1h-2h-4h-6h-8h-10h-12h
• Press the ON/OFF to start the countdown from 0 till the set time is reached, then it stops automatically.
• Press the ON/OFF key again, and the countdown stops.
• Note: Pressing the SET key is invalid during the countdown time. Pressing the ON/OFF key is invalid if the countdown time is not set.

NÄYTTÖ

• The indicator light will flash during the countdown time if it is working.
• The indicator light will be turned OFF when the countdown stops

TEKNISET TIEDOT

• Working voltage: 230V
• Toimintataajuus: 50 Hz
• Max. Nykyinen: 16A
• Max. LoadPower: 3680W
• Precision: +/- 1%

Usein kysytyt kysymykset

How do I know if the countdown is active?
The indicator light will flash while the countdown time is working.

What happens when the countdown finishes?
The timer will automatically stop, and the indicator light will turn OFF.

Can I change the countdown time while it’s running?
No, you cannot. You must stop the current countdown first by pressing the ON/OFF key, and then you can set a new time using the SARJA avain.