igloo SK4 Lockbox Installation Guide

igloo SK4 Lockbox Installation Guide

igloo-LOGO

igloo SK4 Lockbox

igloo-SK4-Lockbox-PRODUCT-IMAGE

Tekniset tiedot

  • IP66 vedeneristys
  • IK-07 level impact protection
  • Supports both battery and DC power
  • Backlit physical keypad
  • algoPIN technology for remote access

Mitä sisältyy

  • Lukkolaatikko
  • Kiinnitysruuvit
  • Ruuviankkurit
  • Screw O-Rings
  • AAA-paristot
  • Akun kansi
  • Säilytyssuoja
  • Pistokkeet

igloo-SK4-Lockbox-IMAGE-1

Mitä tarvitset

igloo-SK4-Lockbox-IMAGE-2

Hei! Aloita tästä

Asennusvaiheet

Asennus ruuveilla

  • Open the lockbox lid and take out all of the items inside.
  • Find a place to install your Lockbox. Installing it closer to your locks and entryway will enable easier operation.

Vaihe 1: Merkitse kiinnitysreiät
Tear off & tape the drill sheet where you would like to install the lockbox and mark the locations of the 4 x pilot holes.

igloo-SK4-Lockbox-IMAGE-3

Vaihe 2: Poraa ohjausreiät

TÄRKEÄÄ
To ensure secure installation, use the recommended pilot hole and anchor bolt guidelines below.

Drill the pilot hole size for the mounting surface as specified. Note if Anchor Bolts are required.

igloo-SK4-Lockbox-IMAGE-4

The pilot holes should be drilled to a depth of 50mm / 2″.

Step 3: Insert Anchors (if required)
Insert the 4 x screw anchors (C) for Brick, Concrete, Masonry or Drywall if required. The anchors should tightly fit into the pilot holes to ensure a secure hold.
igloo-SK4-Lockbox-IMAGE-5

Step 4: Access Mounting Holes
Remove the 4 plugs (H) & storage guard (G) to access the mounting holes.

igloo-SK4-Lockbox-IMAGE-6

Vaihe 5: Kiinnitä ruuveilla
Align the lockbox to the prepared holes and insert the screws (B) with a screwdriver in a clockwise twisting motion. Use the rubber O-rings (D) as shown if exposed to wet conditions.

igloo-SK4-Lockbox-IMAGE-7

Step 6: Replace Storage Guard
Replace the storage guard (G) and snap it into place.

igloo-SK4-Lockbox-IMAGE-8

Vaihe 7: Aseta paristot

  • Open the battery cover (F) and insert the 4 x AAA (E) batteries as indicated. Close the battery cover.
  • For temps below -20C (-4F) use LiMn02 AAA batteries for optimal battery life.

igloo-SK4-Lockbox-IMAGE-9

Vaihe 8: Sulje kansi
Close the lid firmly and the lockbox should automatically lock after 3 seconds with a green Status LED. igloo-SK4-Lockbox-IMAGE-10

Step 9: Test Unlocking
Unlock the lockbox with the default pin by entering the code 1234567890.

igloo-SK4-Lockbox-IMAGE-11

Onnittelut!
You have installed your lock. Download the igloo home application from the App Store or Google Play Store to complete setup & configure your smart lock.

Ominaisuudet

  • Suuri säilytystila
    Ample interior storage to protect more than just keys such as cards, ID badges, fobs, remotes, asset tags, small tools & more.
  • Rugged Outdoor Security
    Built to protect with IP66 waterproofing, IK-07 level impact protection, a secure locking mechanism & tamper hälytyksiä.
  • View Device Activity Logs
    View all access activity by credential used, and view the battery life in the IGH mobile app.
  • Helppo asennus
    Supports both battery and DC power for flexibility in low- or high-traffic areas. The compact design makes it easy to retrofit or install in new builds without complicated wiring.
  • Backlit Physical Keypad
    Large, easy to press, tactile buttons built for reliable PIN code entry and readability in direct sunlight or pitch black conditions.
    Access from Anywhere a igloo PIN technology helps you generate a PIN code from anywhere and share it with anyone for instant access.
  • Apple Watch Convenience
    Use your Apple Watch to unlock via voice, a finger tap or gestures. Works with watch OS 7 and up.
  • Automaattinen lukituksen avaus
    Your lockbox automatically unlocks when you return home. Never fumble with keys again.
  • Relock Reminder
    Intuitive audio and visual alerts will prompt you to recharge the batteries when it runs low.
  • Turvalukitus
    Disable the keypad after several incorrect access attempts to ensure your property is always secure.
  • Decoy PIN-koodi
    Lisää turvallisuutta ja karkoita katsojia syöttämällä satunnaisia ​​numeroita ennen varsinaista PIN-koodiasi.
  • Estehälytys
    The lock will sound an alarm if the bolt tongue cannot be extended or retracted fully to alert the user of any obstructions.
  • Alhaisen akun varoitus
    Intuitive audio and visual alerts will prompt you to recharge the batteries when it runs low.
  • Automaattinen lukitus
    Automatically locks once the lockbox is shut to give you greater peace of mind.
  • Tamper Hälytys
    The lock will sound an alarm if the lid is opened without unlocking to alert and deter potential tampyrityksistä.
  • Hätäkäynnistys
    Easily jumpstart the reader with a Type-C cable connected to a power bank or compatible phone if battery is drained.
  • Äänenvoimakkuuden säätö
    Säädä lukon äänenvoimakkuutta mieltymystesi mukaan. Valitse tasoista 0 (mykistys) - 5 (äänikkäin).

Audio and LED Indicators

Toiminnot Indikaatioita
Bluetooth® Connection Status LED flashes Blue
Lukituksen avaaminen onnistui Status LED blinks Green, 4 fast ascending tones.
Lukittu onnistuneesti Status LED blinks Green, single long beep.
Incorrect Credential Status LED blinks RED, 4 short beeps.
Estehälytys Status LED blinks RED, 4 short beeps, repeated 6 times.
Reached max. no. of digits (16) Status LED blinks RED, 4 short beeps.
Break In Alert Activated Status LED blinks RED, low-high siren for 30 seconds.
Security Lockout Activated Status LED blinks RED, low-high siren for 30 /60 / 90 seconds.
Turvalukitus ei ole käytössä 2 pitkää piippausta.
Alhaisen akun varoitus Status LED breathes RED when woken up, 3 fast descending tones.
Lukitse muistutushälytys uudelleen 2 short beeps, repeated 5 times.
Hard Reset Mode Status LED blinks BLUE, 3 short beeps.
Kova nollaus / pariliitos Status LED blinks RED, GREEN, BLUE, 4 slow descending tones.
Virran käynnistys 2 slow beeps, 2 fast beeps.

Vianetsintä

  • I have placed the batteries inside but the device won’t turn on.
    Check that the batteries have been inserted in the correct orientation. There should be two long, and two short beeps when the batteries are installed correctly. If it still doesn’t work, try a new set of AAA 1.5V batteries.
  • I am unable to see the device when trying to pair
    Ensure that the device is receiving power by pressing any button to wake it up. Waking it up will allow it to be seen in the app when pairing.
  • The batteries have fully drained. How can I replace them?
    Connect a 5V DC power source via Type – C USB cable. The device will wake up, you can now enter a permanent pin code such as the master pin or use the app to unlock. Once unlocked, ensure that a fresh set of batteries have been inserted before closing.

FAQ

What should I do if the lockbox does not automatically lock after closing the lid?

Ensure that the batteries are properly inserted and have sufficient charge. Try replacing the batteries if needed. If the issue persists, contact customer support for assistance.

Can I use rechargeable batteries in the lockbox?

It is recommended to use LiMn02 AAA batteries for optimal performance in temperatures below -20C (-4F). Rechargeable batteries may not provide the same level of performance.

Asiakirjat / Resurssit

PDF thumbnailSK4 Lockbox
Installation Guide · 2AYD7-SK4, SK4 Lockbox, SK4, Lockbox

Viitteet

Esitä kysymys

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Esitä kysymys

Ask a question about setup, compatibility, troubleshooting, or anything missing from this manual.