Johdanto
Thank you for choosing the BIG RED T830025-1 Heavy Duty Hydraulic Steel Service Floor Jack. This manual provides important information for the safe operation, maintenance, and troubleshooting of your new floor jack. Please read and understand all instructions before use to ensure proper function and prevent injury or damage.
Image: The BIG RED T830025-1 Floor Jack, a red hydraulic jack with a black handle and wheels.
Turvallisuustiedot
VAROITUS: Näiden ohjeiden noudattamatta jättäminen voi johtaa vakavaan loukkaantumiseen tai omaisuusvahinkoon.
- Lue aina koko käyttöohje ennen nosturin käyttöä ja ymmärrä se.
- Älä ylitä 3 tonnin (5 000 paunan) nimelliskapasiteettia.
- Käytä vain kovalla, tasaisella alustalla.
- Always use jack stands to support the vehicle immediately after lifting. The jack is a lifting device only, not a vehicle support device.
- Varmista, että ajoneuvo on pysäköintivaihteella (tai vaihde manuaalivaihteistossa) ja seisontajarru on kytketty. Kiilaa pyörät, joita ei nosteta.
- Keskitä kuorma satulaan. Keskittämättömät kuormat voivat kaataa tunkin.
- Keep hands and feet clear of moving parts and the area under the vehicle.
- Älä muuta tunkkia äläkä käytä sitä muuhun kuin aiottuun tarkoitukseen.
- Käytä asianmukaisia henkilönsuojaimia, kuten suojalaseja.
- Inspect the jack before each use for any damage, leaks, or loose parts. Do not use if damaged.
- Laske kuormaa hitaasti ja varovasti.
Asennus ja alkuvalmistelut
Before using your BIG RED T830025-1 floor jack, ensure it is properly assembled and prepared.
- Yhdistä kahva: Insert the two handle sections together. Place the assembled handle into the handle socket on the jack.
- Kiinnitä kahva: Turn the handle clockwise until it is fully tightened and secured in the socket. This also closes the release valve for lifting.
- Purge Air from Hydraulic System (Bleeding):
- With the jack fully lowered, remove the oil filler plug (if present, refer to diagram in full manual).
- Pumppaa kahvaa nopeasti 10–15 kertaa ilman kuormaa.
- Replace the oil filler plug. This helps remove any trapped air.
Image: Diagram showing the wide lifting range and steps for connecting the handle and pumping to raise the saddle.
Käyttöohjeet
Follow these steps for safe and effective operation of your floor jack.
Ajoneuvon nostaminen:
- Valmistele ajoneuvo: Park the vehicle on a hard, level surface. Engage the parking brake and place the transmission in park (or lowest gear for manual). Block the wheels that are not being lifted.
- Aseta Jack: Roll the jack under the vehicle, positioning the saddle directly under the manufacturer's recommended lifting point. Consult your vehicle's owner's manual for proper lifting points.
- Nosta ajoneuvoa: With the handle fully tightened clockwise (release valve closed), pump the handle up and down to raise the saddle. Continue pumping until the vehicle is lifted to the desired height.
- Install Jack Stands: Immediately after lifting, place appropriately rated jack stands under the vehicle's frame or designated support points. Ensure the vehicle is securely resting on the jack stands before performing any work.
- Slightly Lower Jack: Once jack stands are in place, slowly turn the handle counter-clockwise to slightly lower the jack until the vehicle's weight is fully supported by the jack stands. The jack should remain in contact with the vehicle as a secondary safety measure.
Ajoneuvon laskeminen:
- Raise Vehicle Slightly: Pump the jack handle a few times to lift the vehicle slightly off the jack stands.
- Irrota tukijalat: Irrota nostopukit varovasti ajoneuvon alta.
- Alempi ajoneuvo: Slowly turn the handle counter-clockwise to open the release valve. The vehicle will begin to lower. Control the lowering speed by adjusting how much you turn the handle.
- Poista Jack: Once the vehicle is fully lowered to the ground, remove the floor jack.
Image: Illustration of the jack's steel front wheels, 360-degree rotation casters, and its 6000 lbs rated capacity for cars, pickups, and MPVs. A warning states the product is a lifting tool only and requires jack stands for under-vehicle work.
Huolto
Säännöllinen huolto varmistaa nostolaitteen pitkän käyttöiän ja turvallisen toiminnan.
- Voitelu: Voitele kaikki liikkuvat osat säännöllisesti kevyellä koneöljyllä.
- Hydrauliöljyn taso: Check the hydraulic oil level every three months. With the jack fully lowered and on a level surface, remove the oil filler plug. The oil level should be just below the filler hole. Add high-quality hydraulic jack oil if needed. Do not overfill.
- Puhdistus: Keep the jack clean from dirt, grease, and corrosive materials.
- Varastointi: Store the jack in a dry, protected area with the ram fully retracted to prevent rust and seal damage.
- Tarkastus: Before each use, inspect for any signs of damage, leaks, or wear. Pay close attention to welds, wheels, and the hydraulic cylinder.
Vianetsintä
This section addresses common issues you might encounter with your floor jack.
| Ongelma | Mahdollinen syy | Ratkaisu |
|---|---|---|
| Jack ei nosta kuormaa. |
|
|
| Jack nostaa hitaasti tai epäsäännöllisesti. |
|
|
| Jack leaks hydraulic fluid. |
|
|
| Jack ei laske. |
|
|
Tekniset tiedot
Key technical specifications for the BIG RED T830025-1 Floor Jack.
- Malli: T830025-1
- Merkki: ISO PUNAINEN
- Kapasiteetti: 3 tonnia (11 023 paunaa)
- Materiaali: Seosteräs
- Minimum Lifting Height: 5-1/8 tuumaa (13.0 cm)
- Suurin nostokorkeus: 18-5/16 tuumaa (46.5 cm)
- Tuotteen mitat (P x L x K): 22.5" x 12.9" x 6.90" (57.2 x 32.8 x 17.5 cm)
- Kahvan pituus: 39.3 tuumaa (99.8 cm)
- Tuotteen paino: 27.34 kg (60.27 lbs)
- Ajoneuvon huoltotyyppi: Car, Light Trucks, SUVs
- Ominaisuudet: Single Piston Quick Lift Pump, Detachable Handle, Foam Bumper, 360-degree Swivel Casters, Built-in Safety Valve.
Image: Detailed product specification diagram showing the jack's dimensions, minimum and maximum lifting heights, and handle length.
Takuu ja tuki
This BIG RED T830025-1 Floor Jack comes with a 1 vuoden takuu ostopäivästä lukien ja kattaa materiaali- ja valmistusvirheet normaalin käytön aikana.
For warranty claims, technical assistance, or to order replacement parts, please contact BIG RED customer support. Keep your purchase receipt as proof of purchase.
Contact information for BIG RED customer support can typically be found on the manufacturer's official websivustolla tai tuotepakkauksessa.
